Bitter sweet....

[Wodicus]

Well I found a Concept Camero Bumblebee today and I was transforming him back into car mode when his right tire/door section fell off. After checking the part that came off I noticed that it seems that when the figure was being assembled the screw that held the piece in place did not go in properly. Basically it missed the hole it was supposed to go into and was drilled into a section just below it. Anyone got any ideas if I can fix this?

[CobraCommander]

pics?

[Aernaroth]

Theoretically, some epoxy might do the job, but yeah, I can't be sure without pics.

[JaySmith]

Whoops.... I ment to say I'm not surprised actually as the Concept Camaro has been blatently overlooked from the get go. Nothing but terrible problems including horrible paint schemes which include nasty runs and ugly overspray from what I've seen locally anyways.

[Wodicus]

I think I'm just going to take it back, someone has already offered to sell me an extra one they have.