this is going to be basically turning rts windcharger into classics tailgate.
the cost will be one original g1 tailgate fig and a rts windcharger.
start by dissassembling the g1 windcharger.(just a couple small phillips screws and he falls right apart).
next up,use side cutters and buck up his green front bot body half to gain a new face plate.
kapow!!!
remove the stock head from windcharger.you have to remove the screw at the back of his head in order to allow enough play in the socket to release the head.
grind/sand down the front of his face,copying the same angle on the rear of the g1 face plate.the face plate ends up being really thin in the end because of the way his hood flips down in transformation.(more clearance is always good.)
reattach the head and screw,then glue the face plate onto the front of the head.
transform him a few times to check for any clearance issues.
so to recap,he just went from windcharger head to tailgate head.
to be continued....